Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - dana 60s and parts
View Single Post
Old May 14th, 2012, 02:20 PM   #1
boggin-machine
Senior Member
 
boggin-machine's Avatar
 
Join Date: 01-11-06
Location: bay city
Posts: 11,648
iTrader: (31)
Mentioned: 0 Post(s)
Default dana 60s and parts

thinking about selling off some of my parts that it dont look like ill be using unfortunately. i have collected these parts of the past few months and i wish i could still use them.

for the front i have bought a 88 ford hp 60. the axles were taken apart cleaned and inspected for damage.i removed all factory brackets and cleaned up the tubing. i cut off part of the short side diff to make room for link brackets. as of right now the housing is bare with no brackets currently on it.
i have all the needed brackets to 3 link the front suspension for axle side including shock hoops and coil over tabs.

the front axle parts include
  • all 3 link brackets
  • shock hoops
  • link brackets
  • track bar bracket axle and frame side
  • hp60 513 gears
  • install kit
  • spartan locker
  • correct carrier
  • new brakes
  • new solid diff cover
  • track bar hiems
  • tie rod and drag link hiems
all these parts are new un used!!


the rear dana 60 includes
  • spare 60 housing and shafts
  • solid diff cover
  • new 456^ carrier
  • 513 gears with install kits
  • spartan locker
  • disk brake brackets
  • new rotors and pads with calipers

all these parts are new and unused.

i would like to see

i have alot into these axles. id like to see a 4300 for the axles with all parts built and ready to go.


WILL NOT PART OUT. ALL OR NONE.

Last edited by boggin-machine; May 16th, 2012 at 02:44 PM.
boggin-machine is offline   Reply With Quote
 
Page generated in 0.06973 seconds with 20 queries