Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - F'n Rod Bearings?? Drill out ports??
View Single Post
Old May 7th, 2012, 10:15 PM   #1
travis
Member
 
travis's Avatar
 
Join Date: 06-16-09
Location: thompsonville, mi
Posts: 45
iTrader: (1)
Mentioned: 0 Post(s)
Default F'n Rod Bearings?? Drill out ports??

Ok I've had 1 22r and 2 22re's apart now to find bad rod bearings on all of them! WTF? There has to be a root problem here... I noticed there is an oiling port at the base of the rods. When I stuck a drill bit into the hole frome the bearing side I discovered that it necks down right at the end of the port. Can anybody give me a good reason not to drill that out all the way through to maybe help keep those lubed?
travis is offline   Reply With Quote
 
Page generated in 0.05038 seconds with 20 queries