Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - How messed up is this? Superduty axle
View Single Post
Old April 29th, 2012, 10:04 AM   #13
smasheromalley
Senior Member
 
smasheromalley's Avatar
 
Join Date: 11-06-05
Location: Michigan
Posts: 3,038
iTrader: (15)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by natureboynate47 View Post
that seal should have been replaced if that was the side they put ball joints on. it should still be replaced even if you dont have or use vacuum hubs. that seal also helps keep the axle shaft aligned properly. could casue excessive wear on the needle bearing in the
hub that the shaft rides on. btw you also need to use the right tool for pounding that seal on the axle shaft.
They put ball joints on both side. And thanks, that was what i suspected.
smasheromalley is offline   Reply With Quote
 
Page generated in 0.91641 seconds with 20 queries