View Single Post
Old April 25th, 2012, 11:13 PM   #10
Wramblerguy
Senior Member
 
Wramblerguy's Avatar
 
Join Date: 04-02-11
Location: Schoolcraft 49087
Posts: 2,485
iTrader: (8)
i have a factory heater, windsheild squirter and correct collum i will be putting in in the next couple weeks along with a new engine harness and maybe dash harness too
i am also going to put a two way vacuum switch in instead of the one on the transfer case to switch the cad unit on the axle because ive been having problems with it
my future plans also include Wagoneer Dana 44s with 4.88s a Detroit rear and some form of a posi or lunch box up front ( i already have the axles)

a supercharger, i already have the eaton m62 supercharger and all the material and elbows i need to make it work, physically at least, electronics is just the problem



in the distant future my plans include a tummy tuck, a lower profile aluminum fuel tank, a 6 point rollcage (ive already got a fully tied in 4 point roll bar) with removable bars to take the hard top off and on and an aluminum diamond plate front bumper the same style as my rear

Last edited by Wramblerguy; April 30th, 2012 at 05:13 PM.
Wramblerguy is offline   Reply With Quote
 
Page generated in 0.04898 seconds with 11 queries