Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 16.5" double beadlock wheels with 3/16" rod
View Single Post
Old April 25th, 2012, 03:54 PM   #8
Big Block Ranger
bigblockford79's Avatar
Join Date: 05-11-08
Location: Hamilton, MI
Posts: 2,805
iTrader: (24)
Mentioned: 3 Post(s)

Originally Posted by joe_jeep View Post
what about just laying a thick bead of weld and skipping the rod?
Thia would subject the wheel to a lot of heat or take you a long time to weld all 4 if you waited for them to cool between welds. With the rod, a couple good tack welds will do the trick.
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!

"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."
bigblockford79 is offline   Reply With Quote
Page generated in 0.10829 seconds with 22 queries