Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Smittybuilt Xrc Bumpers
View Single Post
Old April 10th, 2012, 11:39 PM   #8
wadey
┌∩┐(_)┌∩┐
 
wadey's Avatar
 
Join Date: 03-31-11
Location: White Lake / Mt. Pleasant
Posts: 1,630
iTrader: (7)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by grnd93 View Post
have the src stinger and rear with swingout on my TJ. they look decent and are heavy as hell. I haven't bashed them on anything yet so I can't speak to the durability. My front I bought used and it was rhinolined since brand new. I did the same for the rear. the tire carrier is factory powdercoat and has held up fine for a year so far. The only thing I have had to do was replace the rub block on the bottom of the latch mechanism. from the factory it is abs plastic and snapped in half from the vibration. Had one made from nylon and it's holding up fine (they also send me a new plastic one under warranty).
Do you have a pic of the broken plastic part? Your opinion on the latch/swing out. Do the frame mounts seem up to par? Also how does the over quality seem? Chincy, poor welds, good, bad, ugly? ect

Thanks
wadey is offline   Reply With Quote
 
Page generated in 0.05001 seconds with 20 queries