Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Welding cast iron exhaust manifold
View Single Post
Old April 6th, 2012, 03:19 PM   #7
DIGnLIFE
Senior Member
 
DIGnLIFE's Avatar
 
Join Date: 09-06-08
Location: Woodhaven, MI
Posts: 111
iTrader: (3)
Mentioned: 0 Post(s)
Default

I have a lot of experience with cast. You need nickel rod and arc for sure. V grove the crack/ joint with a grinder. Pre heat with a torch. Weld it. Nickel rod burns alot different than most arc rods. I would suggest you try a couple times on a scrap manifold to get the feel and heat right.
DIGnLIFE is offline   Reply With Quote
 
Page generated in 0.05232 seconds with 20 queries