Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Fllat flange to flat flange question
View Single Post
Old April 5th, 2012, 11:47 PM   #12
cerial
Senior Member
 
cerial's Avatar
 
Join Date: 09-06-08
Location: Caledonia,MI
Posts: 1,772
iTrader: (3)
Mentioned: 8 Post(s)
Default

Quote:
Originally Posted by Diesel Dan View Post
why not run a ZF6? OR get a new truck.
zf6 ratios
1st 5.79
2nd 3.30
3rd 2.10
4th 1.31
5th 1.00
6th 0.72
rev 5.23

My 6 speed setup ratios
1st 6.68
2nd 3.10
3rd 1.69
4th 1.00
5th 0.72
6th 0.52
rev 8.25

If I wanted to I could leave the 1st brownie in high which would only require 5 shifts.

1st 4.80
2nd 2.23
3rd 1.21
4th 0.72
5th 0.52
6th -
rev 5.94

If I put them both in high I would only have 4 shifts

1st 3.46
2nd 1.60
3rd 0.87
4th 0.52
5th -
6th -
rev 4.27


It is a set it up as your needs change setup. I don't plan on doing any hands off the wheel shifting though so I will probably stick with picking a range and running it.

Last edited by cerial; April 5th, 2012 at 11:54 PM. Reason: .point
cerial is offline   Reply With Quote
 
Page generated in 0.05702 seconds with 20 queries