Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Welding cast iron exhaust manifold
View Single Post
Old April 4th, 2012, 08:27 PM   #2
treky67
millwright/jeepwright
 
treky67's Avatar
 
Join Date: 01-30-09
Location: Windsor Ontario
Posts: 93
iTrader: (0)
Mentioned: 0 Post(s)
Default

Mig will not work at all, will most likely crack. No matter what method you use for welding the cast it will need to be both pre and post heated. Your gonna be best off with you stick welder and a high nickle content rod. Any welding supply shop should be able to point you in the right direction when it comes to a rod specifically for cast iron.
treky67 is offline   Reply With Quote
 
Page generated in 0.04837 seconds with 20 queries