Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Welding cast iron exhaust manifold
View Single Post
Old April 4th, 2012, 07:02 PM   #1
In Da Faaaaaace!!!
Plato2k5's Avatar
Join Date: 12-25-05
Location: WMU Kzoo Mi / Livonia, MI
Posts: 5,620
iTrader: (17)
Mentioned: 6 Post(s)
Send a message via AIM to Plato2k5
Default Welding cast iron exhaust manifold

I have a mig and Arc welder. Can you heat it up to around 600*F and mig it with regular flux core, than throw it in the oven and slowly cool it?

or should I just use the arc welder? What rod ? I have very little experience with the arc welder... what settings?

I'd just rather use the mig unless it will not hold at all
Plato2k5 is offline   Reply With Quote
Page generated in 0.09758 seconds with 22 queries