Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - The Great Dodge Switcheroo Work Truck Project
View Single Post
Old March 31st, 2012, 08:20 PM   #58
kkodet
Formerly Route55
 
kkodet's Avatar
 
Join Date: 01-21-07
Location: Marine City, Michigan
Posts: 4,175
iTrader: (47)
Mentioned: 1 Post(s)
Default

A couple of other notes from the last couple days:

1995 and 1997 Taillight wiring harnesses are different and needed to be swapped.

The doors from the 95 were 1999 factory replacements, presumably under warranty. When I switched over my door handles (to retain my locks) the lock to latch rod had a different attachment and I had to use the rods from my doors to make work.

The 1995 bed used the old style small pin tailgate hinges. I used a newer tailgate and the hinges needed to be swapped.

The plastic license plate holder is MUCH easier to install with the rear bumper off, but can be done with a stubby philips.
kkodet is offline   Reply With Quote
 
Page generated in 0.04436 seconds with 20 queries