Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1% prez........"the jiggler"
View Single Post
Old March 22nd, 2012, 09:37 PM   #801
Senior Member
Tab's Avatar
Join Date: 11-05-05
Location: Freeland, mi
Posts: 5,550
iTrader: (31)
Mentioned: 51 Post(s)

Taking them apart isn't a big deal. Be sure to discharge them before you unthread the bottom though! You should get the aluminum vice blocks too so you can hold the shaft securely while you work on them. And then just be ure to lay everything out carefully and CLEANLY while you disassemble everything. Just nuts and bolts cracker!
Tab is offline   Reply With Quote
Page generated in 0.14568 seconds with 22 queries