Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Axle tube help
Thread: Axle tube help
View Single Post
Old March 12th, 2012, 08:08 PM   #7
SolLess
08' Unlimited JK "X"
 
Join Date: 02-20-06
Location: Westland, Mi
Posts: 329
iTrader: (8)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by COYOTE View Post
What carrier are you using?

35 spline ARB. This is my weekend toy and DD, so I would rather try to build to not break, versus being rushed to fix.

I took measurements tonight. The inner diameter of the axle tubes are currently approximately 1-7/16". The 35 spline RCV's are 1-9/16 at their largest point. So I was pretty damn close at eyeballing it at about an 1/8".

Next question, bore it out to 1-3/4", and have 3/32" around on all sides, or should I plan on the RCV's having a little more run out than that, and go up to 1-7/8" bore?

I'll have to call Advantage and see what they say.

Pic of most of the goods! Just gotta save a couple more duckets and get my ARB here!


Last edited by SolLess; March 12th, 2012 at 08:13 PM.
SolLess is offline   Reply With Quote
 
Page generated in 0.06707 seconds with 20 queries