Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - dadsmudrun 2012 season dates
View Single Post
Old March 12th, 2012, 11:16 AM   #4
dirty addiction
Senior Member
 
dirty addiction's Avatar
 
Join Date: 10-31-08
Location: zeeland mi.
Posts: 730
iTrader: (2)
Mentioned: 0 Post(s)
Default

General Truck Rules



Solid tow out point (Each and every driver MUST pull a cable)

Helmets and seat belts required by all vehicle occupants

Fire Extinguisher on board

GOOD SPORTSMANSHIP is required or you will be asked to leave!

$20 one time entry fee per driver, per truck, per class





Classes and Rules





Class 1 36.5" DOT (non cut) tires and under

4x4 vehicles only-production type frames and suspension

Any motor drive train combination

Front of motor can not be behind center line of front axle

Body swaps allowed with motor in stock location of frame, axles within 6" of center of wheel well

Flat beds and gutting allowed, must maintain stock appearing bodies (not homemade)

Must have doors, hood, and firewall. Replacement fiberglass body or parts ok

Single carb, gasoline only, no nitrous

No aluminum heads or aluminum blocks permitted

Vehicles with factory support of cab cut, or glass removed, open or soft tops MUST have roll bar to the frame

Passengers allowed at the discretion of the track owner

Maximum engine size 514 cubic inches



Class 2 44" DOT (non cut) tires and under

Same rules as class 1



CLASSES 1 AND 2 ARE MEANT FOR LOWER BUDGET BEGINNERS, IF YOU SHOW UP WITH HIGH DOLLAR MOTOR TO RUN THOSE CLASSES, YOU WILL BE BUMPED UP TO CLASS 3 AND 4



Class 3 36.5" DOT (non cut) tires and under

​4x4 vehicles only-production type frames and suspension

Any motor and drive train combination

Body swaps allowed

Flat beds and gutting allowed, must maintain stock appearing bodies (not homemade)

Must have doors, hood, and firewall. Replacement fiberglass body or parts ok

Single carb, gasoline only, no nitrous

No aluminum blocks permitted

Vehicles with factory support of cab cut, or glass removed, open or soft tops MUST have roll bar to the frame

Aluminum heads allowed- conventional type only

Engine set back should be no more than 12" from centerline of axle to #1 spark plug

No aluminum hubs

No nitrogen shocks

No fiberglass or carbon fiber springs allowed

Passengers allowed at the discretion of the track owner

Wide five wheels are ok if they are used with an adapter, no wide five hubs



Class 4 44" DOT (non cut) tires and under

Same rules as class 3



Class 5​ 39.5" DOT tires and under

Cut DOT tires allowed

2"x3" square tube frames ok

4 link and other adjustable suspensions allowed

Engine must be in front of driver

Fiberglass bodies ok, no full fiberglass racing bodies

Max deck height Ford-10.320 GM-10.200 Chrysler-10.72

Alcohol through carb, no injection

Any enclosed transfer cases

Gutting allowed

Must be naturally aspirated

​Small blocks can run a 300 shot of nitrous, iron headed big blocks can run a 250 shot of nitrous

​FIRE SUITS REQUIRED!!!

Minimum four point harness

Roll cage requirements: 6 point minimum, with 4 points to the frame. .090 min thickness 1 5/8 min. on main support

Master kill switch within driver's reach with an exterior kill switch on right rear of vehicle

Maximum wheel base of 150"

Wide five wheels ok

NO PASSENGERS!!!



Class 6 54" DOT tires and under

Same rules as class 5



Class 7

ANYTHING GOES!!

Paddles and tractor tires ok

FIRE SUIT REQUIRED

NO PASSENGERS

Minimum 4 point harness

Roll cage requirements: 6 point minimum, with 4 points to the frame. .090 min thickness 1 5/8 min. on main support​

Master kill switch within driver's reach with an exterior kill switch on right rear of vehicle
dirty addiction is offline   Reply With Quote
 
Page generated in 0.09103 seconds with 20 queries