Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - What the lowest load on heims i should use for a tube cralwler
View Single Post
Old March 5th, 2012, 09:19 PM   #4
Bones's Avatar
Join Date: 11-06-05
Location: South Lyon, MI
Posts: 12,486
iTrader: (39)
Mentioned: 23 Post(s)
Send a message via AIM to Bones

Originally Posted by Tab View Post
A good 3/4 rod end has about a 76k radial load rating. But the bigger issue is the shank bending/breaking. Why do want the weakest you could use when you could just get the size that works best and is safest?
Exactly what tab said. i would recommend a 3/4" bore witha 7/8" shank

buy these.

I think he even offers a greatlakes4x4 discount.

EDIT- this is assuming you are building a tube rig under 4500 lbs and under 450 hp. If this is a 600hp rig on rockwells, you'll need bigger. I just saw you are from TN, and there are some big rock rods down there.
Inviscid Motorsports

Special Thanks and Recommendations to;
Motorcity Machines
Ironman Offroad
Branik Motorsports
Maxxis Tires

Raceline Wheels
PAC Racing Springs
Joint Clutch and Gear
Bones is offline   Reply With Quote
Page generated in 0.11951 seconds with 22 queries