Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Ford vs Chevy Dana 44 Parts
View Single Post
Old March 2nd, 2012, 07:20 PM   #1
Senior Member
Join Date: 04-19-07
Location: Hope/Sanford/Midland, MI
Posts: 861
iTrader: (16)
Mentioned: 0 Post(s)
Send a message via AIM to jeepxj2007
Default Ford vs Chevy Dana 44 Parts

I am building a Ford L.P. Dana 44 for my truggy. I picked up a set of chevy knuckles, single piston caliper brackets, and spindles all from the chevy so I can run high steer since they are all set up for them. When I put these knuckles on what should I order the ball joints for? The ford or the chevy or doesn't it make a difference because they are more than likely the same? I was curious of that....and if they are different and I do need the chevy ones what year should I say it is from if ordering from rockauto to ensure I order them for a 44 and not a 10 bolt?
jeepxj2007 is offline   Reply With Quote
Page generated in 0.17431 seconds with 22 queries