this computer doesn't have the right programs to view the prints and follow the wires, but it will be a BN/LB (brown base, light blue stripe) wire
EDIT- Actually I just looked again.... when the seat belt buckle switch is open, it reads that the belt is buckled. When it reads that the switch is closed, it reads the belt is unbuckled. So you should just be able to cut that wire and not have to worry about the module. Although I'll be the first to admit I hate wiring... so I don't know what that will do to your restraint control mod. Best way to find it might be to locate the door chim wires. The buckle switch wire should be in the same loom as the door chime (unless it is easy to spot under the seat)
Special Thanks and Recommendations to;
PAC Racing Springs
Joint Clutch and Gear
Last edited by Bones; December 23rd, 2005 at 11:18 AM.