View Single Post
Old February 19th, 2012, 07:44 PM   #16
Tab
Senior Member
 
Tab's Avatar
 
Join Date: 11-05-05
Location: Freeland, mi
Posts: 4,768
iTrader: (29)
Mentioned: 2 Post(s)
Default

Quote:
Originally Posted by BennettisTileCo View Post
If the mounting geometry stays the same it will work like it should. If it raises your mounting pOint for your Uca then it changes the geometry for the long arm kit.
The radius arm geometry on a radius arm setup does almost nothing except to keep the axle from rotating. I does nothing to control pinion or caster movement through the range of motion like a 3 or 4 link.
Tab is offline   Reply With Quote
 
Page generated in 0.03855 seconds with 11 queries