Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 2000 ZR2 4x4 issue
View Single Post
Old January 28th, 2012, 02:40 PM   #12
snow-turtle
Selective Hearing
 
snow-turtle's Avatar
 
Join Date: 06-11-11
Location: CO
Posts: 500
iTrader: (0)
Mentioned: 1 Post(s)
Default

The vac lines come out of the tcase , go under the pass side body . Then one up by the manfold . I had one get a hole there . When you put the lines back on the switch . you got a good seat and back on the right line . Also at the actuator , a good seat . The way I teasted the actuator . Push it in cover each hole with you fingers , it won't inflate . Go to the car wash , wash the underside (if there's dirt or put glass on) Start at the tcase and follow each line . Its a pin hole in the line or a bad seat at the end .

Here are two links for you , just to have . I have crawled all over and around , For a pin hole in a dam vac line . At times I have thought about just replaceing all the lines .

http://www.s10forum.com/forum/f220/t...thread-327817/
http://www.4x4posi-lok.com/PDFs/troubleshootguide.pdf
snow-turtle is offline   Reply With Quote
 
Page generated in 0.05539 seconds with 20 queries