Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Pushing the Dana 44 TTB
View Single Post
Old January 23rd, 2012, 07:54 AM   #1
Coyote Red
Senior Member
 
Coyote Red's Avatar
 
Join Date: 08-24-11
Location: Chelsea, MI
Posts: 1,028
iTrader: (7)
Mentioned: 2 Post(s)
Default Pushing the Dana 44 TTB

Well there is no ice to fish on, and few rabbits to hunt. So it is fabrication time for the '91. How far can you push the Dana 44 TTB before custom length axles are needed, how much wheel travel have you achieved, have you tried heim joints for the beam pivots, and how far should I extend the radius arms?

The plan for now is to machine out the beam pivots and install weld in heim joints, build 4" drop brackets around the joints, build extended radius arms with heim joints, re-engineer the steering links to follow the beams full range of motion, and with any luck pull about 12" of wheel travel. Is there anything that I need to be aware of as I start designing and fabricating the parts?

I want to find the limits of this set up before I go through the SAS route.
Coyote Red is offline   Reply With Quote
 
Page generated in 0.05538 seconds with 20 queries