Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 351w build
Thread: 351w build
View Single Post
Old January 14th, 2012, 02:31 PM   #9
TurdBronco
Senior Member
 
Join Date: 11-14-05
Location: Center Line
Posts: 988
iTrader: (6)
Mentioned: 0 Post(s)
Send a message via AIM to TurdBronco
Default

No reason to machine the block if the cylinder walls don't need it.
Change heads or pistons.
Or you could machine the heads and intake to get some more compression but then you have to check piston to valve clearance and pushrod length.

What is the goal?

10.5:1 is pushing it on pump gas depending on what the timing is at.
TurdBronco is offline   Reply With Quote
 
Page generated in 0.05856 seconds with 20 queries