Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Project Jimmycon (full width tons jk) REAL Cost!!
View Single Post
Old January 14th, 2012, 12:30 AM   #60
indy
Senior Member
 
indy's Avatar
 
Join Date: 01-08-09
Location: Fort Gratiot
Posts: 381
iTrader: (7)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by JohnnyJ View Post
I think that was Christmas of 2002. You're getting old. (Luckily I'm not!)

Looks good. How's it ride?
It rides great on the trailer, unless your refering to pushing it out of the garage! Leahs right it was a rocket with two hillbillys riding it down the driveway!!
Other than that, the brakes are done, steering done, switched to a Rock solid front track bar with sector brace. It hits my hi steer arms at full lock so I'm just going to put some stops in. Its getting a cutting brake anyway so hopefully I won't miss a little turning radius. Switched to a Synergy rear trackbar.
The down side, I bought JE REEL drive shafts, and they aren't shipping out untill Monday! The up side. .120 wall shafts instead of .083
For this weekend I guess I'll rework my Shrock works rockers so they work with the long arm, I wasn't going to because of the whole cutting up perfectly good parts thing, but then I rememberd that I just cut a ton of stuff off a fairly new jeep!
indy is offline   Reply With Quote
 
Page generated in 0.05976 seconds with 20 queries