Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - F150 SAS Truggy
Thread: F150 SAS Truggy
View Single Post
Old January 12th, 2012, 07:04 PM   #66
jeepxj2007
Senior Member
 
Join Date: 04-19-07
Location: Hope/Sanford/Midland, MI
Posts: 834
iTrader: (16)
Mentioned: 0 Post(s)
Send a message via AIM to jeepxj2007
Default

I finished all the 4 link stuff for the rear...minus the fact that I need to buy coils and shocks...coils I'll probably order in the next couple days..with taxes I'm gonna buy some nice bilstein shocks for it I am thinking.







Besides the coils I need to weld those upper tabs out...I mounted the lower link mounts with 3 1/2" gr8 bolts and then welded both ends to the frame...I figure that should be sufficient enough..I didn't even bother boxing the frame there because they tie into the cab crossmember and it braces the bottom of the frame to the top so it basically is doing the same. The rear axle is ready to go together and start the disc conversion on it.

Last edited by jeepxj2007; April 13th, 2012 at 09:39 AM.
jeepxj2007 is offline   Reply With Quote
 
Page generated in 0.06779 seconds with 20 queries