Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - TREC Class C "ZJ"
View Single Post
Old December 17th, 2011, 12:33 AM   #4
COYOTE
Cup holders & Rollbars
 
COYOTE's Avatar
 
Join Date: 01-31-09
Location: Zeeland, MI
Posts: 468
iTrader: (10)
Mentioned: 0 Post(s)
Default

First time trussing an axle so be nice.

I first spent half a day designing and trial fitting metal. Finally came up wth this.





Here is my donated axle. I had to cut off lower control arm brackets and clean up.




I added some gussets to help keep everything straight.





I tacked on the bottom truss and then went for it. While burning it on I welded a couple of inches at a time at different areas so I would'nt bend the housing, but I stayed at it so the axle would only have to cool once. When I looked up once I was done it was 2am.







Last edited by COYOTE; December 17th, 2011 at 12:39 AM.
COYOTE is offline   Reply With Quote
 
Page generated in 0.06485 seconds with 20 queries