Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Never Enough.....SAS blaZeR2
View Single Post
Old December 9th, 2011, 06:08 PM   #138
Senior Member
TanTahoe's Avatar
Join Date: 08-13-07
Location: Shelby Township, MI
Posts: 496
iTrader: (9)
Mentioned: 0 Post(s)

Originally Posted by wadey View Post
Hmmm for some reason there is a disassembled cherry picker in my apartment

Ok so I gave on trying to track down why my truck won't start. I've just been throwing parts and $$$ at it, so it was time to swap in a running motor, harness, and computer. Freak is dropping the motor off on sunday, so until then I'll be striping and getting the old motor ready to pull. For the new motor I have picked up a new oil pan gasket, rear main seal, timing set and gasket kit, exhaust manifold gaskets, and valve cover gaskets. Is there anything else that you would replace on a used motor short of a full rebuild?

Id replace the intake gaskets while your at it. Those 4.3 seem to have issues with them.
TanTahoe is offline   Reply With Quote
Page generated in 0.14980 seconds with 22 queries