Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Mid-Engine Sand rail Project
View Single Post
Old December 1st, 2011, 09:20 PM   #30
Muddynobs
Newbie
 
Join Date: 12-01-11
Location: California
Posts: 1
iTrader: (0)
Mentioned: 0 Post(s)
Default

That there rail was once owned by me from calli!!! Wow still has same accel coil/Koni front shocks/monroe rears/ even last paint job looks to be same minus paint on arms and rest of what was chrome. Looks killer now with disc brakes/new paddles and cleanup! Hopefully motor is still set up right.... It lopes well with the big cam. 13 was small of a tire and just was not hooking right but once it grabbed it flew. Even beat sum v8's. Tranny was also done pretty tuff(hard parts sum saver, as I pulled 16 but with half cut rib around and still spun them easy. Only thing was the belt always flies off cause of the higher than stock revving. A gator back would last the weekend(lol). It was built for glamis! I then put on eBay years ago and sold to someone in Michigan. Now you have it... Wow looks killer!


Ps-if still same paint, I have sum laying around still...hehe
Muddynobs is offline   Reply With Quote
 
Page generated in 0.05695 seconds with 20 queries