Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - WJ: Why wouldn't it fit?
Thread: WJ: Why wouldn't it fit?
View Single Post
Old November 23rd, 2011, 07:29 PM   #3
Senior Member
Dylan's Avatar
Join Date: 08-24-06
Location: K-zoo
Posts: 1,145
iTrader: (7)
Mentioned: 0 Post(s)

If its anything like the AWD ZJ, its probably because of possible driveline issues. The front of the ZJ I had was a CV joint driveshaft. Not the double C joint but an actual CV. The normal slip yoke was not there also. This caused my CV to pull apart with a little bit of wheeling. It was a simple fix buy swapping yokes and front driveshafts.

I'm sure the lift will work, you jut may have to figure out the driveline angles yourself.
Dylan is offline   Reply With Quote
Page generated in 0.05499 seconds with 21 queries