Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - bead lock ring print
View Single Post
Old September 29th, 2011, 08:44 AM   #1
Broke wheeler
GMKLR50's Avatar
Join Date: 10-13-10
Location: White Lake, MI ( Detroit side of state)
Posts: 1,171
iTrader: (5)
Mentioned: 0 Post(s)
Question bead lock ring print

I am looking for the print (drawing) of the dememsions for a 16.5 inch beadlock rings. I have access to everything needed to make / design these rings but the only thinng I know for sure is the thinknees of the material. I have never made a set or owned a set so I am kinda going blind in to what it takes to make a set of rings that will work. I reallt just need the dia of each or where they mount on the rims or how much bigger the outside ring needs to be.

If someone can help me out that would be great.


also if anyone has done a weld in saftey lip on a 16.6 that woulds help for my inner bead...this is all new to me.

Last edited by GMKLR50; September 29th, 2011 at 08:54 AM.
GMKLR50 is offline   Reply With Quote
Page generated in 0.12073 seconds with 22 queries