Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 97 chevy cummins swap
View Single Post
Old September 24th, 2011, 08:18 PM   #29
sbcrichie
R&R Fabwerks
 
sbcrichie's Avatar
 
Join Date: 08-30-09
Location: sturgis/michigan
Posts: 1,505
iTrader: (10)
Mentioned: 4 Post(s)
Default

made a heat shield for the down pipe and mounted the 95 accumulator. The 95 accumulator has different hose placements so the hoses clear the down pipe better.



made this bracket for the gm alternator


bad pic but you can see where i machined the stock water neck to place the gm alternator


got the throttle cable and cruise control cable hooked up. i used a throttle cable for a throttle body truck instead of the vortec truck, you can use either cable but mine was worn out so i figured i would replace with this one since it is a little shorter than the vortec




had to move the shifter hole back about 4" so i made this plate to cover up the old hole




the stock shift lever would have hit the console so instead of trying to bend the lever that goes into the tranny i built a hotrod kenworth wanna be shifter
Attached Thumbnails
Click image for larger version

Name:	cummins swap 26.jpg
Views:	2458
Size:	23.7 KB
ID:	83820   Click image for larger version

Name:	cummins swap 27.jpg
Views:	2777
Size:	25.4 KB
ID:	83821   Click image for larger version

Name:	cummins swap 28.jpg
Views:	2321
Size:	22.2 KB
ID:	83822   Click image for larger version

Name:	cummins swap 24.jpg
Views:	2420
Size:	25.3 KB
ID:	83823   Click image for larger version

Name:	cummins swap 25.jpg
Views:	2299
Size:	24.1 KB
ID:	83824  

Click image for larger version

Name:	cummins swap 29.jpg
Views:	2295
Size:	22.7 KB
ID:	83825   Click image for larger version

Name:	cummins swap 23.jpg
Views:	2269
Size:	20.7 KB
ID:	83826   Click image for larger version

Name:	cummins swap 22.jpg
Views:	2297
Size:	24.9 KB
ID:	83827  
sbcrichie is offline   Reply With Quote
 
Page generated in 0.17043 seconds with 23 queries