Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Fanuc Robots
Thread: Fanuc Robots
View Single Post
Old September 24th, 2011, 05:34 PM   #18
old newb
pfreer's Avatar
Join Date: 07-21-08
Location: Independence KY
Posts: 155
iTrader: (1)
Mentioned: 0 Post(s)

Sounds like your light curtain isn't interlocked correctly, should be tied into your master on circuit, which will dump main power immediately, not just fault circuit. Certainly if you have workers anywhere near that light curtain its not controlled safe enough.

Fanuc are not bad robots, we use quite a few of them, probably most of our maintenace crews favorite out of Nachi/Denso.

Last edited by pfreer; September 24th, 2011 at 05:39 PM.
pfreer is offline   Reply With Quote
Page generated in 0.14964 seconds with 21 queries