Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Fanuc Robots
Thread: Fanuc Robots
View Single Post
Old September 24th, 2011, 03:55 PM   #5
Senior Member
Disturban's Avatar
Join Date: 02-28-08
Location: Lowell, MI
Posts: 2,794
iTrader: (2)
Mentioned: 0 Post(s)

Originally Posted by gofastbobby View Post
Operator did not touch anything, it was in automode when it started doing it and they called me out to fix it.

It will not stop moving and it is not making any of the prox switches, it is traveling to the end of the axis but I don't see a prox signal being made even though the prox lights up, I think it has a bad board.

I am going to try to switch out the board from another bot and verify.
Disturban is offline   Reply With Quote
Page generated in 0.06490 seconds with 20 queries