Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Best way to build centered housing axle.
View Single Post
Old September 22nd, 2011, 06:17 PM   #9
ron86toy
R&V Ranger
 
ron86toy's Avatar
 
Join Date: 10-09-06
Location: Beaverton/ Edenville,mi
Posts: 1,033
iTrader: (10)
Mentioned: 1 Post(s)
Send a message via Yahoo to ron86toy
Default

you can always save your money and run the stock housing with a cv on the driveshaft...same route I am doing with an fj80 rear...Collin(from GA.) has been running one for a while in his Taco that way and no problems...daily drives it too

got cope?\\\\\\\\\\'s Tacoma Evolution - TTORA Forum
ron86toy is offline   Reply With Quote
 
Page generated in 0.05077 seconds with 21 queries