Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Samurai third member swap HELP!
View Single Post
Old September 8th, 2011, 10:59 AM   #6
orionn
Senior Member
 
orionn's Avatar
 
Join Date: 12-15-05
Location: Ypsilanti
Posts: 1,372
iTrader: (62)
Mentioned: 0 Post(s)
Default

Just to compile the info here, and add a little:

Front tracker thirds fit in the samurai axles.

Used in the front, they bolt in.
Used in the rear, you swap in your samurai side gears first.

In the front the aluminum third member will hold up prety well, but the rear should have the gears swapped to the Samurai steel third member.
Besides, the Samurai carrier is a 4 pin carrier (stronger). you will need to add a shim to the ring gear and a aftermarket retainer ring for the cross pins (or tack weld the cross pins in place)

Remember, only the Tracker front thirds and gears fit the samurai axle housings.

Its prety simple really.

hope that clears it up for you.

Last edited by orionn; September 8th, 2011 at 11:06 AM.
orionn is offline   Reply With Quote
 
Page generated in 0.05427 seconds with 20 queries