Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1995 Bronco rear shackel flip
View Single Post
Old September 5th, 2011, 07:43 PM   #6
Senior Member
Lilmuddy's Avatar
Join Date: 11-28-07
Location: Attica, Ohio
Posts: 157
iTrader: (9)
Mentioned: 0 Post(s)

IIRC the shackle flip nets more then 3.5" of lft. Do a search over on FSB in the SAS section and you will find the answer. The axle does move 1-1.5" forward and most fix it with a zero rate block. Pinion angle rotates up also but everyone that I know that has done results in the pinion pointing directly at the case as needed. As long as the stock shaft is long enough and doesnt slip apart during full suspension flex you should be ok.
Lilmuddy is offline   Reply With Quote
Page generated in 0.15590 seconds with 22 queries