Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 1999 Blazer NV236 4X4 not working
View Single Post
Old August 25th, 2011, 09:21 AM   #4
cornrowcornilius
Senior Member
 
Join Date: 08-19-09
Location: Three Rivers/ MI
Posts: 975
iTrader: (9)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by RADRICK View Post
Were the terminals corroded on the harness & the tccm ? The corrosion could have worked into the module. I assume that since you knew about cleaning them you know how common it is for the module to go bad. I'd try a new tccm, or a known good one.
No corrosion. Last night I disconnected the battery and touched the cables together per direction from another site. Now the it seems as if it is stuck in 4HI, the light on the switch flashes. If I push any of the buttons that button will flash a half dozen or so times then go back to 4HI. I can hear the axle actuator when I push the button...but that seems like the only thing that is happening. So does this sound like tccm, encoder, or actuator?
cornrowcornilius is offline   Reply With Quote
 
Page generated in 0.06248 seconds with 20 queries