Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Is this a dana 60 front axle?????
View Single Post
Old August 12th, 2011, 09:35 PM   #9
Big Block Ranger
bigblockford79's Avatar
Join Date: 05-11-08
Location: Hamilton, MI
Posts: 2,805
iTrader: (24)
Mentioned: 3 Post(s)

Originally Posted by littletrucker View Post
If it has kingpins, should be a dead giveaway for a dana 60, the ujoint is much larger, and i believe dana 60 hubs should be a full 4 inches, the hd 44's neck down kinda.. And it should have 60 on the housing
This is more indicative of the internal style locking hubs. Dodge used the external style which is little more to differentiate.

Either look at the casting for "44" or "60" cast into the webbing under the axle centerline or pull a lockout off and count splines. Dana 44 fronts are 19 spline and 60's are 30 spline on the stub shafts.
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!

"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."
bigblockford79 is offline   Reply With Quote
Page generated in 0.13135 seconds with 22 queries