Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - 350 chevy (motor sold)
View Single Post
Old August 10th, 2011, 03:13 AM   #1
spr_chicken
Senior Member
 
spr_chicken's Avatar
 
Join Date: 05-12-08
Location: Grand Haven / Michigan
Posts: 1,116
iTrader: (9)
Mentioned: 0 Post(s)
Send a message via MSN to spr_chicken Send a message via Yahoo to spr_chicken
Default 350 chevy (motor sold)

1986 (ish) 350 chevy came out of a van

edelbrock 1406 carb (600 cfm with electric choke)
edelbrock torker intake
no distributor, fuel pump, exhaust, motor mounts
new flywheel and starter

It has been reringed and had new bearings put in it. It had less than 10,000 miles on it when I got it. It now has about 15,000 miles on it. When I pulled it out of the truck I baught it in it was leaking antifreeze from the freeze plug behind the starter. I replaced that freeze plug and have not had any other problems with it.

I want $350 cash or will trade

---I also have---
-a new distributor and external coil. $150 sold
-a set of conversion motor mounts to install it in a toyota. $150
-a set of center dump ram horn exhaust manifiolds (accessory bracket was cut off drivers side) $50 sold
-a complete serpentine setup $75 sold
-a complete serpentine setup (power steering pump, alternator, and a/c) $75

Last edited by spr_chicken; December 3rd, 2011 at 01:13 PM.
spr_chicken is offline  
 
Page generated in 0.06116 seconds with 20 queries