Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - My 99 XJ now build thread
View Single Post
Old July 27th, 2011, 12:50 PM   #52
alix4d
Proud Owner of 0 Jeeps
 
alix4d's Avatar
 
Join Date: 09-06-09
Location: Rochester Hills, Michigan
Posts: 521
iTrader: (4)
Mentioned: 0 Post(s)
Default

Well the trac-bar has finally become a severe issue....

The Jeep started sounding weird and I noticed the engine leaning to one side.



Broken passenger side engine mount was the culprit.



After removing the mount I found to my excitement that the weight of the engine busted a nice hole in the distributor.



The trac-bar has a severe bend in it now.



I was emailing a tech at rustysoffroad about it and he offered to send me the straight one for $130 and I felt that since they had changed the design they should cover part of it. He asked for my info and sure enough an hour later I received a call from Rusty himself. I was surprised at first that he would take the time to call me but he said he had never seen anything like it before and that they jump their 6.5" kit 6 feet off the ground with no issues.
He told me I could go measure what I needed to have and they would build it for $60. That seemed very fair and once again I am extremely satisfied with their service.
alix4d is offline   Reply With Quote
 
Page generated in 0.07404 seconds with 20 queries