Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Never Enough.....SAS blaZeR2
View Single Post
Old July 21st, 2011, 07:52 PM   #29
wadey
┌∩┐(_)┌∩┐
 
wadey's Avatar
 
Join Date: 03-31-11
Location: White Lake / Mt. Pleasant
Posts: 1,630
iTrader: (7)
Mentioned: 1 Post(s)
Default

Ok I have a few questions about setting up gears. How do you measure for the shims on both the pinion and the side bearings? I have seen it on Extreme4x4 but haven’t found out how to do it myself.

Also are there any tricks or tips on how to set up gears in an axle that is still in the car?

What is the proper gear oil to break in a set of gears? Regular oil for break in then full synthetic like a motor, or just run full synthetic from the start?

Any links or advice would be greatly appreciated as I’m setting up the rear end tomorrow.

Thanks
wadey is offline   Reply With Quote
 
Page generated in 0.05099 seconds with 20 queries