Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - D44 in the Grand
View Single Post
Old October 2nd, 2006, 01:16 PM   #16
Grandman
do i look old !
 
Grandman's Avatar
 
Join Date: 11-05-05
Location: West Branch Mi
Posts: 9,864
iTrader: (7)
Mentioned: 3 Post(s)
Default

I dont want to have 2 wheel patterens front to rear , I installed a Ford 8.8 in the rear and dont want to change that , The wheels i have are nothing special , stell wheels but the center would easily fit over the 44 hubs .

Redrilling the hub on the front is posible if there is enough room on them to redrill hub and rotor . Maybe redrill the steel wheel instead ? drill the spare allso so it fits either axel . They use to make a lot of after market ( fit all ) wheels . OEM made spares that way in the past also , they had one wheel with 8 or 10 holes in it to put into diferent models i recall .

I dont like spacers , there not the safest thing around . I did think of 1 spacer to carry so a spare could be put on one axle , or put on the other axel with spacer . That way 1 spare will fit either .


Looking for suggestions , digging up parts and then ill make a decision .
Grandman is offline   Reply With Quote
 
Page generated in 0.58957 seconds with 20 queries