Got the new front brake setup installed this morning. My factory set-up was old and sloppy and I felt unsafe, so I purchase conversion brackets to switch over to cheby 3/4 parts. For the most part everything was bolt on, I did have to grind a couple spots a little to provide better clearance but not much. The biggest issue was not having any instructions to clarify with bracket was left or right and where the thin shim went (could go next to the knuckle or spindle). I ended up having to try all 4 combos before getting the right setup.
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!
"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."