Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Plasma Table ***SOLD!!!!****
View Single Post
Old June 2nd, 2011, 10:25 AM   #7
Destr0
Senior Member
 
Destr0's Avatar
 
Join Date: 06-22-10
Location: Hebron, IN
Posts: 413
iTrader: (6)
Mentioned: 0 Post(s)
Default

I may have a used Hypotherm plasma available soon that should go right on this table.

We have two of them, both will cut up to 3" steel, but I believe we have an older Hypotherm 200 amp plasma cutter getting sold soon.
If anyone buys this and needs help getting it setup on a computer, that is what I do for a living (IT Manager for a fortune 500 steel service center).

See my avatar for an example of what you can do with a CNC plasma cutter. The Jeep logo is 3/8" thick floor plate.
~K
Destr0 is offline  
 
Page generated in 0.04989 seconds with 20 queries