Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - New rear bumper is finished.
View Single Post
Old May 18th, 2011, 08:17 PM   #5
Bones's Avatar
Join Date: 11-06-05
Location: Dearborn Heights, MI
Posts: 12,036
iTrader: (38)
Mentioned: 8 Post(s)
Send a message via AIM to Bones

Originally Posted by Mclovin View Post
yea that gusseted 1/4" plate aint gonna hold shit
Actually, the way it is gusseted (ony 1/2 way down the tab), one solid pull from the D rings on a 45 degree angle will bend the mounting tabs where the tabs meet the end of the frame

The better way to gusset it would be to move the gussets to the outside part of the frame, and run the gussets the full length of the tab (from the bumper to past where it bolts to the frame. That way, the entire tab will be strong in all 3 dimensions from the point it bolts to the frame all the way to the D ring.
Inviscid Motorsports

Special Thanks and Recommendations to;
Motorcity Machines
Ironman Offroad
Branik Motorsports
Maxxis Tires

Raceline Wheels
PAC Racing Springs
Joint Clutch and Gear
Bones is offline   Reply With Quote
Page generated in 0.06788 seconds with 21 queries