Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Century 180 Mig - great price
View Single Post
Old May 14th, 2011, 09:36 PM   #13
Dirty Turtle
Senior Member
 
Dirty Turtle's Avatar
 
Join Date: 11-17-05
Location: Grand Blanc
Posts: 1,760
iTrader: (22)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by XJcoupe View Post
after checking your above link, yes yours comes with a hose/reg, but to run mig, you need a few more parts, like changing the hose liner inside your hose, for -25/30 solid mig wire, like this kit
http://www.centurytool.net/Mig_Conve...5_p/k610-2.htm
The welder already has that. The hose is used for both. The same as my miller was. I used flux just fine, then used mig without having to change the hose liner. I just had the switch the solenoid in the welder itself.

The link I posted even says, it just needs the nozzle and different wire and after an hour of search (not to prove you wrong, but to reassure myself) I found this http://www.weldingmart.com/sitemedia...02010.pdf?seo=

which if you go down to the 180's specs it says exactly what is needed for mig. You need the gas kit (which is included in the model i got, but not the regular 180) wire, and a nozzle!

The kit you posted is for the 120v to change over to mig.
Dirty Turtle is offline   Reply With Quote
 
Page generated in 0.06048 seconds with 20 queries