Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Dana 44 steering knuckle swap
View Single Post
Old May 12th, 2011, 09:27 PM   #4
Senior Member
insaneoffroader's Avatar
Join Date: 03-11-08
Location: Allegan
Posts: 2,509
iTrader: (11)
Mentioned: 1 Post(s)

Originally Posted by dirtrider View Post
does this also mean that you can go the other way, use a chevy knuckle and then running a ford spindle bearings, brakes ect. I am looking to run a for 9" rear, 5 x 5.5 bp and then run a chevy front 44 and need to get it to 5 x 5.5 bp.
No. You have to use the ford knuckle with the ford spindle. The knuckle to spindle bolt pattern on a chevy is 6 bolt; ford knuckle to spindle is 5 bolt.
If parts ain't flyin' you ain't tryin'

Last edited by insaneoffroader; May 12th, 2011 at 09:30 PM.
insaneoffroader is offline   Reply With Quote
Page generated in 0.12418 seconds with 22 queries