Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Pretty much fucked, need some advice
View Single Post
Old May 5th, 2011, 05:44 PM   #5
chadcooper55
expert jeep disassembler
 
chadcooper55's Avatar
 
Join Date: 08-28-08
Location: kent city mi
Posts: 8,033
iTrader: (20)
Mentioned: 10 Post(s)
Default

Quote:
Originally Posted by Disturban View Post
I would probably cut the other side off and clean them both up and bevel the edges and weld them both on at the same time. If one broke do you trust the other?

dont bevel the edges as stated above just butt them up to the tube and weld them. with a fillet weld you just need your weld to be as thick as the thinnest part that you are welding to.
chadcooper55 is offline   Reply With Quote
 
Page generated in 0.24930 seconds with 20 queries