Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Axels: Rubi Dana 44 F & R 5:13, Alloy Shafts
View Single Post
Old April 27th, 2011, 11:51 PM   #10
Melmo
Member
 
Melmo's Avatar
 
Join Date: 03-03-11
Location: Burlington, WI
Posts: 75
iTrader: (0)
Mentioned: 0 Post(s)
Default

I am looking into the stock brackets now but another good option would be for you to look at a full traction ultimate lift kit. That would give you a tringulated rear upper and you would only need the spring buckets and shock mounts then. The front is not an issue anyway as the three remaing brackets are oem now anyway.

Also if you already have axles with stock brackets on them it would be pretty darn easy to cut them off and move them to these axles.

Also I was assuming you had a TJ but then I saw your signature and though it might be an XJ which would make it even easier to do.
Melmo is offline   Reply With Quote
 
Page generated in 0.05353 seconds with 20 queries