Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Dana 44 steering knuckle swap
View Single Post
Old April 21st, 2011, 10:23 PM   #2
bigblockford79
Big Block Ranger
 
bigblockford79's Avatar
 
Join Date: 05-11-08
Location: Hamilton, MI
Posts: 2,761
iTrader: (24)
Mentioned: 0 Post(s)
Default

Yes is will work - providing that you use the Chevy components from the knuckle out including the stub shaft. The chevy spindle is a 6 lug at the knuckle where the Fords were all 5 bolt.
__________________
If you can read this, thank a teacher. If you can read it while pooping, thank Bill Gates!

"A girls butt hole is like a 9 volt battery. You know its wrong, but eventually you put your tongue on it."
bigblockford79 is offline   Reply With Quote
 
Page generated in 0.05737 seconds with 20 queries