Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - cutting 1/8" steel?
View Single Post
Old April 17th, 2011, 01:32 AM   #20
BlzrNick
Built not bought
 
BlzrNick's Avatar
 
Join Date: 09-22-09
Location: Grand Rapids, MI
Posts: 519
iTrader: (2)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by redline8300 View Post
I'll admit to being a sissy, but when you get the metabo get some dust masks as well. I got tired of blowing crap out of my nose for a week after building my front bumper.

Why are you using 1/8", or is this some type of a skin over thicker wall tube?
1/8" is all i really need. I dont plan on running in to sh!t. All it really needs to do is hold my fairlead.

Quote:
Originally Posted by Strangler View Post
If your using a circular saw, I assume your cutting sheet- I use a sabre saw with metal blades.
Yeah, it started as a 3x7 sheet. So far i like the 4.5" angle grinder the best. Im able to make the cuts fairly straight and its faster than my old circular saw.
BlzrNick is offline   Reply With Quote
 
Page generated in 0.07961 seconds with 20 queries