Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - YJ renewal!
Thread: YJ renewal!
View Single Post
Old April 3rd, 2011, 11:05 PM   #15
Senior Member
yyj87's Avatar
Join Date: 04-10-10
Location: Traverse city(Silver Lake)
Posts: 1,719
iTrader: (1)
Mentioned: 0 Post(s)

Finished doing all of the cutting I wanted to do on the drivers side floor boards, Everything is cut back to 100% solid/weldable steel.

If your doing sheet metal work you need a set of these!

Cobalt air sheers, Box says 18 GA and smaller but it rips through the 16GA like its nothing.

Here is what I actually accomplished today.

My sheet metal butt welds are far from perfect, they seem to have good penetration and I only burned through once. The patch is warped just a smidgen at the bottom, My rocker guards will straighten it out.

I will slow down on the next patch to keep the warping to a minimum.

Tomorrow will bring more, I had a lot of other crap going on and spent maybe 3 hours in the garage today. Just the dogs and I home tomorrow, Ill be able to spend all day on this thing.

Last edited by yyj87; April 19th, 2011 at 10:33 PM.
yyj87 is offline   Reply With Quote
Page generated in 0.12964 seconds with 22 queries